We Understand Your Equipment & Solve Your Problems

When your press person is pulling their hair out 
because the 2 color job doesn’t fit, 

it’s time for a T-51 Targeting Service.
(Itek & Ryobi 2800,3200, & AB Dick 360,375,385,9800's & 9900's)

The T-51 has a procedure to go through called Targeting. This
is when you print 2 plates with common targets in all 4 corners.
You are able to get the 4 targets to line up perfectly through
adjustments and pressures.

Put 2 plates on the press that have cut marks in all 4 corners. Run some
samples and position the non op side and don’t even look at the operator side.
That means raise and lower and twist the non op side into position. Once the
non op side is in position, then look at the operator side to see if the marks fit.

If It Doesn’t Fit, 
It’s Time To Call: 760-751-9531

Contact Information:   

               Office Phone:    (760) 751-9531      
                                                            NOTE:  IF YOU CALL THE OFFICE, YOU WILL
                                                                                      GET VOICE MAIL. Please Leave a message.  
                                                                                           We Do Return Calls Quick                           

            Electronic Mail:    joe@printtech.info

            Postal Address:     Print Tech
                                    1026 W. El Norte Parkway #120
                                     Escondido, CA 92026

Send mail to webmaster@printtech.info with questions or comments about this web site.